Altec 19 cabinet rebuild

[bowtie427ss]

My intentions is to build new cabs out of Baltic birch (3/4. or 1" not sure)

They won't be model Nineteens anymore. As much as engineering tries to avoid it, the material used has an effect on the sonic signature.

As soon as your build deviates from the original design it becomes a facsimile rather than a clone. If you feel a material change is an improvement to the design, by all means implement it. Just do not assume that the next model Nineteen enthusiast that comes along is going to use the same points of reference in his observations and assessments.

also I think it will be easier to sell down the line. (whenever that is!)

YMMV, but experience has taught me NOT to build to predictions of the future, but rather the most practical goals within the present time.

While some enthusiasts are all about modifications and improvements, in the more general marketplace of collectors and vintage enthusiasts mods and improvements will more often serve to de-value a piece compared to bone stock originals simply by narrowing the field of interested parties in the marketplace.

OTOH, i understand that your factory cabinets are damaged, potentially beyond practical repair.

In a nutshell, my advice would be to base all of your building goals on what is going to please you most in the here and now as well as the immediate and foreseeable future.

Just my .02, some folks opinion will certainly vary.

[GM]

+1. Long term with simple to build cabs that's been structurally damaged is to assume its collectible value is strictly from whatever the components will bring + maybe materials cost for the cabs and if you're happy with the muted sonic signature of thin veneer clad MDF, you may find the ~ cubic order of magnitude* increase in panel stiffness of 3/4", and especially 1", BB ply a bit too 'bright'/'sharp' for lack of a better description, forcing adding mass to dampen it and even then may not get it exact enough if comparing to your age deteriorated original.

* Panel stiffness [MOE spec] increases at the cube of thickness and factor in that the MOE average for 3/4" MDF is ~527 k psi Vs 19 mm BB ply's ~1.8 mil psi, it takes a 1.25" thick MDF panel to ~match it and a bit more if gluing together two panels, though not two 3/4" as some have done IIRC from dim memory.

GM

[Aceydeucy]

They won't be model Nineteens anymore. As much as engineering tries to avoid it, the material used has an effect on the sonic signature.

As soon as your build deviates from the original design it becomes a facsimile rather than a clone. If you feel a material change is an improvement to the design, by all means implement it. Just do not assume that the next model Nineteen enthusiast that comes along is going to use the same points of reference in his observations and assessments.

YMMV, but experience has taught me NOT to build to predictions of the future, but rather the most practical goals within the present time.

While some enthusiasts are all about modifications and improvements, in the more general marketplace of collectors and vintage enthusiasts mods and improvements will more often serve to de-value a piece compared to bone stock originals simply by narrowing the field of interested parties in the marketplace.

OTOH, i understand that your factory cabinets are damaged, potentially beyond practical repair.

In a nutshell, my advice would be to base all of your building goals on what is going to please you most in the here and now as well as the immediate and foreseeable future.

Just my .02, some folks opinion will certainly vary.

You're correct. The "here and now is first and salability should be a distant second. Thanks for the input